Ok, this is it! MERRY XMAS TO ALL!!!

Whacko on holiday!!!!

Ok, this is it! MERRY XMAS TO ALL!!!

Whacko on holiday!!!!

SLACKER!!!!!!!!

You stopped a bit early - it wasn't even Christmas day

It's all relative, you know. Space time. The empty space between my ears and the time I take to fill an empty (void)

Happy holidays!
Whacko

OK I lied, I'm back! These folks at home are all tanked up, it got boring, so I'm bright eyed and bushy tailed and they are vocally impaired!

Whacko

Welcome back Whacko, (you seem bored an anxious to help.)
I've got a question for ya. I'm running Mach3 Turn... Thread cutting with the wizard and hand writing the code.. How can I make the threading tool pull out,(X pos.), and not leave a 60 deg. groove at the end of the thread ? Seems like whatever I do, I can't make it look like I cut it manually. I have double nuts on the ball screw and ZERO backlash but can't make it pull out right. 
Thanks Whacko, or anyone else.
RC

I tried rpm from 1300 , 700,  and  400.... all the same. Also varied the pull-out angle. No change.
Would like to extend each pass, (Z-) but don't know how...

Old habits die hard. I was a lecturer, seems I still want to lecture! LOL! Can you post one of your nc part programs? Let's have a look.

Whacko

SURE !
I gotta run out to the shop and copy it...................................be right back. DON"T GO NOWHERE!

Here