Machsupport Forum

Third party software and hardware support forums. => dspMC/IP Motion Controller => Topic started by: olaf884 on May 25, 2022, 10:24:22 AM

Title: Control analog outputs
Post by: olaf884 on May 25, 2022, 10:24:22 AM

Hi,

I'm using the DSPMCv3-S with 8 analog outputs, but I cannot seem to figure out how to use the analog outputs.
I want to control several 0-10V analog valves with these outputs.
Where can I find the command needed to send some values to these outputs (preferably via the c-macro)?

Kind regards,
Olaf

Title: Re: Control analog outputs
Post by: Vital System Support on May 26, 2022, 05:58:39 PM

Hello Olaf

Please send an email to support@vitalsystem.com with a screenshot of VSI device manager with the "Activations" tab open. The controller has to be connected to the computer and selected in the device manager for it to show up.

We can then lay out the options on how you can control the analog outputs for valve control applications.

Regards