Hi, is it possible to change the settings for the feed rate at the startup the program?
I think it's 6 units now and when using millimeter as unit my jogging is very slow.

Roger

Feed and Jog are not the same

Here is how you can change each one
To set the feed put an F(whatever you like) into the Init String on the Config Settings page

and to change the slow jog rate press Tab and you will get a fly out with all the jog settings.. there is a slow jog %, change that till you are happy

Hi Brian,

Could you, please, help me to undesratnd where I find "init String" and "Configuration Settings page"?

I want to change the initial Feed rate.

Thank you,

Zoltan

Hi, Zoltan

This is for Mach3D1.90.07? and on.

Top left of screen click on Config, select General Config...., find Startup Modals, Put a check in Use Init String on ALL "Resets Box", then Add your F-speed in window just below, after the G80, then click OK.

Hope this helps, Chip