Hi,
No, I am not set up in metric. Here is what else I did, After, I could not not make the Ports and Pins trial work, I went in and manually edited the XML file to make sure Enable 1 was set to 0. That didn't make any difference so I erased the XML file and went into MachTurn 2.0 and set it up again. I needed to adjust the motor speed anyway. That did not make any difference. I suspect the problem is not in the XML file. Is there any place else I should check? I can live with it if necessary since everything else is working fine. It is hooked up and running.
Thanks
Lee