Hello Guest it is December 27, 2024, 12:59:03 PM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: Safe version # for Turn?  (Read 2958 times)

0 Members and 1 Guest are viewing this topic.

Offline DICKEYBIRD

*
  • 436 436
Safe version # for Turn?
« on: December 09, 2012, 05:05:45 PM »
What's the least buggy version of Mach 3 Turn?  Mine is R3.043.022

I've finally got my opto home switches up & working on the ORAC and want to get this thing into a solid configuration.  I'm pretty sure the weird things it's doing are due to my ignorance but I want to make sure I'm starting with as solid a version as possible as I go forward.  What version are you guys using that actually make parts consistently with your lathes?  I'm using a solid PC with a good PP (no external controller.)
Logged
Milton from Tennessee ya'll.

Offline RICH

*
  • *
  • 7,427 7,427
Re: Safe version # for Turn?
« Reply #1 on: December 09, 2012, 05:23:24 PM »
For  threading should be > than 3.042.033. You may want to check Ron's recomendations if using the NFS Turn wizard.
RICH
Logged

Offline DICKEYBIRD

*
  • 436 436
Re: Safe version # for Turn?
« Reply #2 on: December 09, 2012, 05:51:21 PM »
Thanks Rich, I'll install .033 and go from there.
Logged
Milton from Tennessee ya'll.

Offline DICKEYBIRD

*
  • 436 436
Re: Safe version # for Turn?
« Reply #3 on: December 09, 2012, 08:55:38 PM »
Hmmm, went to the old versions page and their isn't an .033 version listed??
Logged
Milton from Tennessee ya'll.
Pages: 1   Go Up
« previous next »