Thanks for the response...
I have it setup as a pmw but I had a higher frequency than that. So tomorrow I am going to try your settings.
The weird thing about this board is ..
I am using a PC power supply since I gutted an old rack mount pc. I have one of the 5v outs to power the C11.
So I have a complete separate 12v supply. But whenever I connect the wire to the 12v input on of the relays just humming..
Even if that 12v supply us not plugged into 120v.
Now if I use one of the 12v outs of the pc supply it does not humming
But I get no more than about 300mv out of the 0-10 out.
And all I am doing is driving a DC motor. So just replacing the pot on the Harbour Freight mill.
I don't have a VFD...
The default profile from CNC4PC I think assumes that the spindle will be controlled using Pulse and DIR method.
I don't know why you want the analog 0-10V since you did not say whether you are using a VFD inverter or not and have not named the brand and model.
Anyway, I am showing you how you can get 0-10V - just follow my 2 uploaded attachments.
Reuel