Hello Guest it is December 26, 2024, 06:13:41 AM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: What breakout board to use with Smoothstepper?  (Read 13889 times)

0 Members and 1 Guest are viewing this topic.

Offline dar303

*
  • 37 37
What breakout board to use with Smoothstepper?
« on: October 13, 2010, 09:59:51 AM »
I'm considering Smoothstepper for laptop use on a small desktop PCB/engraver, what do you guys use as breakouts?
Logged

Offline Hood

*
  • 25,835 25,835
  • Carnoustie, Scotland
Re: What breakout board to use with Smoothstepper?
« Reply #1 on: October 14, 2010, 02:58:50 AM »
PMDX 122

Hood
Logged

Offline ger21

*
  • *
  • 6,295 6,295
    • The CNC Woodworker
Re: What breakout board to use with Smoothstepper?
« Reply #2 on: October 14, 2010, 07:21:54 AM »
PMDX-126
Logged
Gerry

2010 Screenset
http://www.thecncwoodworker.com/2010.html

JointCAM Dovetail and Box Joint software
http://www.g-forcecnc.com/jointcam.html

Offline dar303

*
  • 37 37
Re: What breakout board to use with Smoothstepper?
« Reply #3 on: October 15, 2010, 05:23:11 AM »
Thanks! The 126 look good!
Logged

Offline rustybfl

*
  • 16 16
Re: What breakout board to use with Smoothstepper?
« Reply #4 on: December 15, 2010, 05:51:35 AM »
is the PMDX-126 a better board then the C23 - Dual Port Multifunction CNC Board
from CNC4PC and if yes then why?
Thanks Rusty
Logged

Offline Hood

*
  • 25,835 25,835
  • Carnoustie, Scotland
Re: What breakout board to use with Smoothstepper?
« Reply #5 on: December 15, 2010, 06:02:18 AM »
No experience with CNC4PC stuff but I can say that the PMDX boards are excellent quality and I have never seen anyone have one fail.

I have had one PMDX for probably 7yrs and another for 5 and the others 4 and all have worked right out of the packing and never missed a beat.
Hood
Logged

Offline M250cnc

*
  • 591 591
Re: What breakout board to use with Smoothstepper?
« Reply #6 on: December 15, 2010, 12:50:14 PM »
No experience with PMDX but lots with CNC4PC stuff

I am very happy with it and would buy from them again

HTH
Phil

Logged
The Good Thing About Mach3, Is It's very Configurable

The Bad Thing About Mach3, Is It's Too Configurable
Pages: 1   Go Up
« previous next »