What do you guys think of their pricing on their stepper parts? I thought they were pretty decent and looks like should work pretty good. Any feed back apreciated, and yes im new here!

http://web2.automationdirect.com/adc/Search/Search?searchquery=stepper&cmd=Search&fctype=adc.falcon.search.SearchFormCtrl&TxnNumber=-1

I have sent you a PM.

Brett

For a begginer Geckos are your best bet.  They will even replace one drive if you fry it.  And they handle some seriuos beatting.
http://www.geckodrive.com/

I have used the AD motors and cables with Gecko drives in the past

For a begginer Geckos are your best bet. They will even replace one drive if you fry it. And they handle some seriuos beatting.
http://www.geckodrive.com/

Actually there is where my first experience with motion control came, worked on a Practical Cnc table, which the gecko drive failed on, and no they did not replace it for free. Very good people to deal with though and very helpful.

At 114 it is just about free in the past I have used drives that cost me  10X  Not a bad deal!

At 114 it is just about free in the past I have used drives that cost me 10X Not a bad deal!

Never meant to say it was a bad price, theyre prices are extremly good. And i most likely wil end up going with them. Their G203V drives seem quite nice, i might get those.