Hello Guest it is December 26, 2024, 10:17:51 PM
Profile Guest
« previous next »
Pages: « 1 2   Go Down

Author Topic: New to all this!  (Read 35873 times)

0 Members and 3 Guests are viewing this topic.

Offline mcateercustom

*
  • 17 17
Re: New to all this!
« Reply #10 on: June 12, 2012, 09:13:51 AM »

I have probably  asked this question before   ;D but the better question would have been which free cam program would do it in case of cambam not?
Logged

Offline RICH

*
  • *
  • 7,427 7,427
Re: New to all this!
« Reply #11 on: June 12, 2012, 05:17:56 PM »
None that i know of else I would not have purchased anything and would be using it.
But then I may be out of touch with the latest free offerings out there.

All my 3D work is done in CAD and use Meshcam to generate the code.
It works for me and the price was right for what i wanted to do.....your preferences could be different.
RICH
Logged

Offline mcateercustom

*
  • 17 17
Re: New to all this!
« Reply #12 on: June 12, 2012, 05:29:53 PM »
Hey thanks RICH! I'll be sure to check that out! I have been diggin and diggin through piles of different software, it's hard to just make a decision. Thanks for all your patience and informative help!
Logged

Offline jeep534

*
  • 123 123
  • From the hills of WV
Re: New to all this!
« Reply #13 on: February 16, 2013, 08:27:49 AM »
have you looked at Vcarve by vetric not free but not terribly expensive either

archie =) =) =)
Logged
Facebook archies machine
Pages: « 1 2   Go Up
« previous next »