Hello Guest it is January 15, 2025, 01:11:08 AM
Profile Guest
« previous next »
Pages: « 1 2 3   Go Down

Author Topic: Auto tool measuring and offsets  (Read 21491 times)

0 Members and 1 Guest are viewing this topic.

Offline Mountainman

*
  • 155 155
Re: Auto tool measuring and offsets
« Reply #20 on: December 09, 2012, 01:10:39 PM »
can't we rewrite that part of MACH so that G43 controls the knee instead of Z?  Thanks for clearing things up? 
Logged

Offline BR549

*
  • 6,965 6,965
Re: Auto tool measuring and offsets
« Reply #21 on: December 09, 2012, 01:30:28 PM »
(;-) No

(;-) TP
Logged

Offline vertcnc

*
  • 13 13
Re: Auto tool measuring and offsets
« Reply #22 on: March 10, 2013, 11:03:43 PM »
BR549,
I was using your code for tool setup and all was fine. Setup table. Ran some code with tool changes and everything was fine.
I then went to setup some additional tools and after 1st touch off of tool it drove tool through table. Any ideas?
Logged

Offline BR549

*
  • 6,965 6,965
Re: Auto tool measuring and offsets
« Reply #23 on: March 11, 2013, 12:24:45 AM »
Are you sure it was MY code? I have not played with tool offset/setting code for years that I can remember.

Just a thought, (;-) TP
Logged

Offline BR549

*
  • 6,965 6,965
Re: Auto tool measuring and offsets
« Reply #24 on: March 11, 2013, 12:49:41 AM »
I guess IF I read UP the list I would have seen it(;-)

Sounds like Mach3 failed to stop on the probe trip as a best guess.

(;-) TP
Logged

Offline vertcnc

*
  • 13 13
Re: Auto tool measuring and offsets
« Reply #25 on: March 11, 2013, 08:06:34 AM »
Yup that's what I was thinking, but it appears to be something to do with the 2002 variable where it lift the tool .2 above the first touch. Instead of lifting it goes down further. It stops at the first touch.
Logged
Pages: « 1 2 3   Go Up
« previous next »