Hello Guest it is January 15, 2025, 06:00:29 AM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: SPINDLE FREQUENCY?  (Read 2657 times)

0 Members and 1 Guest are viewing this topic.

Offline marlondave

*
  • 4 4
SPINDLE FREQUENCY?
« on: February 16, 2016, 12:17:41 PM »
I bought and installed a 1.5kw water cooled spindle which is run by a requisite inverter. Now whenever I switch the spindle on it triggers the limit switches and I can't reset it until I switch the spindle off. I'm virtually at a stand-still. Any help? The spindle runs independently of the Mach software by the way.
Logged

Offline william55

*
  • 58 58
Re: SPINDLE FREQUENCY?
« Reply #1 on: February 16, 2016, 01:50:39 PM »
I am a newbie here and still learning, but sounds like you need shielded cable. I am sure the more experienced  people here can explain but the electrical noise from the inverter can trigger an Estop
Bill
Logged

Offline marlondave

*
  • 4 4
Re: SPINDLE FREQUENCY?
« Reply #2 on: February 17, 2016, 10:44:35 AM »
I think you may be right Bill, so I'm going to do just that...fingers crossed. :)
Logged

Offline robertspark

*
  • 595 595
Re: SPINDLE FREQUENCY?
« Reply #3 on: February 18, 2016, 09:57:11 AM »
You can add some debounce to your settings... That will aide in removing or masking some of the noise

Check your cable routing.

You can add some 0.1uF ceramic capacitors (100nF)

Rob
Logged
Rob

Albert Einstein ― “If you can't explain it to a six year old, you don't understand it yourself.”
Pages: 1   Go Up
« previous next »