Hello
Guest
it is
August 31, 2024, 07:42:26 PM
Guest
Login
Register
Menu
Home
Help
Search
Login
Register
YouTube
Machsupport Forum
/
Mach Discussion
/
General Mach Discussion
/
Change Wiring
« previous
next »
Print
Pages:
1
Go Down
Author
Topic: Change Wiring (Read 2280 times)
0 Members and 1 Guest are viewing this topic.
kolias
1,163
Change Wiring
«
on:
February 04, 2017, 01:58:44 PM »
My setup with the G540 is all complete and works fine but the motors direction is not the way I wanted. Like when I press the page UP keyboard button the Z axis goes down. I know I can change the Active Low from green to red or from red to green or perhaps from the Homing / Limits page click on the Reverse column?
It’s also easy for me to switch the motor wiring but I don’t know which pair. From the attached Keling wiring schematic which pair of wires will change the motor direction?
Logged
Nicolas
joeaverage
7,581
Re: Change Wiring
«
Reply #1 on:
February 04, 2017, 05:15:26 PM »
Hi,
just change one pair, keep the blue and red together and the green and yellow together, but swap the terminals
in which they go.
Craig
Logged
'I enjoy sex at 73.....I live at 71 so its not too far to walk.'
kolias
1,163
Re: Change Wiring
«
Reply #2 on:
February 04, 2017, 06:16:19 PM »
Thanks Craig, will give it a try
Logged
Nicolas
ger21
6,295
Re: Change Wiring
«
Reply #3 on:
February 04, 2017, 09:36:19 PM »
Checking the Reverse column is a lot easier than changing wires.
Logged
Gerry
2010 Screenset
http://www.thecncwoodworker.com/2010.html
JointCAM Dovetail and Box Joint software
http://www.g-forcecnc.com/jointcam.html
kolias
1,163
Re: Change Wiring
«
Reply #4 on:
February 04, 2017, 10:10:40 PM »
You are right Gerry, wiring was not as easy as i thoought and the Reverse column did the trick, thanks
Logged
Nicolas
Print
Pages:
1
Go Up
« previous
next »