Hello Guest it is February 05, 2025, 07:53:11 AM
Profile Guest
« previous next »
Pages: « 1 2   Go Down

Author Topic: Radius to end of arc differs from start  (Read 5522 times)

0 Members and 1 Guest are viewing this topic.

Offline Wattsy

*
  • 6 6
Re: Radius to end of arc differs from start
« Reply #10 on: November 19, 2020, 01:11:12 PM »
Does anyone know how I can fix the problem  in Mach 3  ?? 
Logged

Offline TPS

*
  • 2,545 2,545
Re: Radius to end of arc differs from start
« Reply #11 on: November 19, 2020, 02:14:04 PM »
pls post your "Profile".xml file
Logged
anything is possible, just try to do it.
if you find some mistakes, in my bad bavarian english,they are yours.

Offline Graham Waterworth

*
  • *
  • 2,756 2,756
  • Yorkshire Dales, England
Re: Radius to end of arc differs from start
« Reply #12 on: November 20, 2020, 03:21:04 PM »
The code I posted was in Diameter mode so if you change Mach to diameter mode all should look good.

Are you using Radius mode for any special reason, most lathes are programmed Diameter.
Logged
Without engineers the world stops
Pages: « 1 2   Go Up
« previous next »