Hello Guest it is December 21, 2024, 07:42:12 AM
Profile Guest
« previous next »
Pages: « 1 2   Go Down

Author Topic: Sure Servo drives with Mach  (Read 12869 times)

0 Members and 1 Guest are viewing this topic.

Offline panaceabeachbum

*
  • 338 338
Re: Sure Servo drives with Mach
« Reply #10 on: April 15, 2008, 10:52:18 AM »
thank you for the diagram , now I just need to figure out motor tuning and setting the drive to the proper mode
Logged

Offline panaceabeachbum

*
  • 338 338
Re: Sure Servo drives with Mach
« Reply #11 on: April 15, 2008, 12:43:37 PM »
back on the subject of using the sure servo drive with mach , is the 5v common shown in the diagram +5v or -5v . My break out board has a jumper to choose the common terminals as - or + ,I am sure this is a simple thing I should know but I am a machinist and my knowledge of electronics is very limited
Logged

Offline sshneider

*
  • *
  • 401 401
Re: Sure Servo drives with Mach
« Reply #12 on: April 15, 2008, 04:16:34 PM »
Usually the Common is the Neg (-)

HTH,
Sid
Logged

Offline Brian Barker

*
  • *
  • 3,860 3,860
Re: Sure Servo drives with Mach
« Reply #13 on: April 15, 2008, 05:54:12 PM »
It was done to the +5 side..
Thanks
Brian
Logged
Fixing problems one post at a time ;)

www.newfangledsolutions.com
www.machsupport.com

Offline sshneider

*
  • *
  • 401 401
Re: Sure Servo drives with Mach
« Reply #14 on: April 16, 2008, 10:28:41 AM »
Ooops- Sorry about that.  Thanks for the correction Brian!

Sid
Logged
Pages: « 1 2   Go Up
« previous next »