Ok so can you  do a longer G0 move and roughly measure with a tape that its near.
Hood

Might also verify that the + and - directions are correct in config.
RC

confusion after rechecking i don't think this can be but x1.0=.075 and x-1.0=6.0 will have to followup tomorrow morning off to thr mine

Ok
So  i have checked and things still seem abnormal would it help to post my xml config files to try and resolve my issues.

I have seen others post to resolve there issues

Richard

Yes Richard,
  Please post your XML.
Hood or someone else will most likely decipher it for you later, it's Greek to me or I'd try to help you out.

You might go over your "Steps Per" again in Motor Tuning and make sure your calculations are correct for each axis.
RC

Yes post your xml. Also please give info about drives, motors, reduction if any etc.
Hood

4x SideStep Bi-Polar Stepper Motor Driver
4x HT23-400-4 400ozin Stepper Motor
PBX-2 Parallel Port Breakout Board
1/2-10 acme lead w/antibacklash nuts

What do you have your stepper drivers set to full, 1/2, 1/4, 1/8 step or what?

Is the motor 1:1 to the leadscrew?

Graham

at this time it's set to 1/4 step and is 1:1

Hi tenhrdaz:

I had similar problem, please check X, Y, Z axis directions (Config--Home/Limits).

Regards

Richard