Hello Guest it is December 26, 2024, 09:02:28 PM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: Which Manual?  (Read 4232 times)

0 Members and 1 Guest are viewing this topic.

Offline Ted383

*
  • 3 3
Which Manual?
« on: January 27, 2010, 10:51:49 AM »
Newb here. I am looking for a Mach3 manual to use with my PlasmaRoute/Thermodyne plasma table. I am using SheetCAM, MP300 DTHC and steppers. Mach is ver R3.042.20. The .pdf's I've seen seam to be for milling and turning.

-ted

.
« Last Edit: January 27, 2010, 11:07:43 AM by Ted383 »
Logged

Offline Hood

*
  • 25,835 25,835
  • Carnoustie, Scotland
Re: Which Manual?
« Reply #1 on: January 27, 2010, 11:38:08 AM »
Dont think there is a manual specific to plasma but the mill manuals mention the settings I think. There may be a video but again I am not sure.
Hood
Logged

Offline Ted383

*
  • 3 3
Re: Which Manual?
« Reply #2 on: January 30, 2010, 03:26:25 PM »
Thanks. I looked the mill manual over and saw a couple references to plasma cutting so I took the .pdf to Staples and they printed the 157 pages for $13.

-ted
Logged

Offline Hood

*
  • 25,835 25,835
  • Carnoustie, Scotland
Re: Which Manual?
« Reply #3 on: January 30, 2010, 03:29:14 PM »
:) sounds like a decent deal

Hood
Logged
Pages: 1   Go Up
« previous next »