Hello Guest it is December 26, 2024, 07:41:21 AM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: Serial Card  (Read 7859 times)

0 Members and 1 Guest are viewing this topic.

Offline giordano

*
  • 56 56
Serial Card
« on: January 17, 2006, 09:20:57 AM »
Hi to all. I have found a serial card of interface in the site
www.cncitalia.net realized through a microcontroller PIC18F452. Could Mach3 pilot a serial card and like? Thanks, Giordano.
« Last Edit: January 17, 2006, 09:55:31 AM by giordano »
Logged

Offline Brian Barker

*
  • *
  • 3,860 3,860
Re: Serial Card
« Reply #1 on: January 17, 2006, 12:21:30 PM »
IF it is to get a comport on your computer I think so... I can't read the page :(

Sorry
Logged
Fixing problems one post at a time ;)

www.newfangledsolutions.com
www.machsupport.com

Offline giordano

*
  • 56 56
Re: Serial Card
« Reply #2 on: January 17, 2006, 05:57:13 PM »
Quote from: Barker806 on January 17, 2006, 12:21:30 PM
IF it is to get a comport on your computer I think so... I can't read the page :(

Sorry
I apologize. The site is this http://www.iprocam.com /
Logged

Offline Brian Barker

*
  • *
  • 3,860 3,860
Re: Serial Card
« Reply #3 on: January 17, 2006, 07:22:38 PM »
I See!! I don't know if the Cam from this will work in Mach 3... This software can run a machine and has Cam built in so I think it is going to make code for it's self.
There could be others out there that have used it in the past.
Logged
Fixing problems one post at a time ;)

www.newfangledsolutions.com
www.machsupport.com
Pages: 1   Go Up
« previous next »