Hello Guest it is December 30, 2024, 12:58:09 PM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: Notify me when done?  (Read 4212 times)

0 Members and 1 Guest are viewing this topic.

Offline bitviper

*
  • 11 11
Notify me when done?
« on: August 22, 2014, 05:07:56 PM »
Any way I can get mach3 to run a program when it's done milling?  I can then make that program email me or something so I don't have to go keep checking on it.
Logged

Offline ger21

*
  • *
  • 6,295 6,295
    • The CNC Woodworker
Re: Notify me when done?
« Reply #1 on: August 22, 2014, 05:27:40 PM »
Search here. It's possible for Mach3 to email you. There should be instructions here somewhere
Logged
Gerry

2010 Screenset
http://www.thecncwoodworker.com/2010.html

JointCAM Dovetail and Box Joint software
http://www.g-forcecnc.com/jointcam.html

Offline bitviper

*
  • 11 11
Re: Notify me when done?
« Reply #2 on: August 22, 2014, 05:28:48 PM »
:)

I did search for "email" and "notify" before posting.  Saw a lot of stuff unrelated.  Will look some more then.
Logged

Offline JohnHaine

*
  • 889 889
Notify me when done?
« Reply #3 on: August 23, 2014, 04:35:04 AM »
You could clamp a mobile phone on the table set on SMS with a message to you ready to go, then get the mill to stop its spindle, move over to the send button, and gently press it?

;>))
Logged

Offline dude1

*
  • 1,253 1,253
Re: Notify me when done?
« Reply #4 on: August 23, 2014, 06:26:48 AM »
its been done seen it on you tube  it was NYC CNC   
https://www.youtube.com/watch?v=pUre4c79p8I&list=UUe0IyK4ntgdPTTjsxjvyHPg
Logged

Offline ger21

*
  • *
  • 6,295 6,295
    • The CNC Woodworker
Re: Notify me when done?
« Reply #5 on: August 23, 2014, 07:07:12 AM »
Logged
Gerry

2010 Screenset
http://www.thecncwoodworker.com/2010.html

JointCAM Dovetail and Box Joint software
http://www.g-forcecnc.com/jointcam.html

Offline ger21

*
  • *
  • 6,295 6,295
    • The CNC Woodworker
Re: Notify me when done?
« Reply #6 on: August 23, 2014, 07:19:55 AM »
Also, you might want to contact Terry and see if he can direct you to it.
http://www.machsupport.com/forum/index.php/topic,27120.msg192417.html#msg192417
Logged
Gerry

2010 Screenset
http://www.thecncwoodworker.com/2010.html

JointCAM Dovetail and Box Joint software
http://www.g-forcecnc.com/jointcam.html
Pages: 1   Go Up
« previous next »