Hello Guest it is December 26, 2024, 02:17:35 PM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: Zoom without mouse wheel??  (Read 6133 times)

0 Members and 1 Guest are viewing this topic.

Offline Davek0974

*
  • 2,606 2,606
Zoom without mouse wheel??
« on: April 15, 2015, 10:35:17 AM »
Is it possible to zoom the path display without a mousewheel?

Yes I know mice are like 50p each but heyho  ;)

Or is it possible to have it auto-zoom to fit the job each time you load code??
Logged

Offline BR549

*
  • 6,965 6,965
Re: Zoom without mouse wheel??
« Reply #1 on: April 15, 2015, 10:53:30 AM »
Mach3 will automatically ZOOM TO the ToolPath selection. IF you have selected TABLE then it zooms to TABLE size. IF it is PART it zooms to PART size.

I will check on the zoom without wheel deal.  BUT I don't think you can.

(;-) TP
Logged

Offline Davek0974

*
  • 2,606 2,606
Re: Zoom without mouse wheel??
« Reply #2 on: April 15, 2015, 10:59:05 AM »
ooh, where are table and part selected?

:)
Logged

Offline Overloaded

*
  • *
  • 4,922 4,922
Re: Zoom without mouse wheel??
« Reply #3 on: April 15, 2015, 12:47:07 PM »
Quote from: Davek0974 on April 15, 2015, 10:35:17 AM
Is it possible to zoom the path display without a mousewheel?

Sure.
Hold the Shift key and left mouse button.
Then slide the mouse in the Y direction.
 :)
Logged

Offline Davek0974

*
  • 2,606 2,606
Re: Zoom without mouse wheel??
« Reply #4 on: April 15, 2015, 02:28:19 PM »
Thanks
Logged
Pages: 1   Go Up
« previous next »