Hello Guest it is December 26, 2024, 09:18:34 AM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: M3-M5  (Read 5775 times)

0 Members and 1 Guest are viewing this topic.

Offline ayhan

*
  • 12 12
M3-M5
« on: April 04, 2008, 03:14:35 AM »
Hello everyone, :)

After M3 or M5 command axes wait nearly 2 seconds, for spindle turn (or off).
How can I change waiting time as 0 (zero) ?

Ayhan
Logged

Offline jimpinder

*
  • 1,232 1,232
  • Wakefield, West Yorks, UK
Re: M3-M5
« Reply #1 on: April 04, 2008, 03:59:26 AM »
See Config/Ports and Pins/Spindle Setup.

You can configure the delay to what you want for M3,M4 and M5
Logged
Not me driving the engine - I'm better looking.

Offline ayhan

*
  • 12 12
Re: M3-M5
« Reply #2 on: April 04, 2008, 04:22:14 AM »
I did

Excuse me, for it , I did not notice "spindle setup" before.

Thank you very much.

Ayhan
Logged
Pages: 1   Go Up
« previous next »